CAMERA IN THE COLD, RAIN & SNOW
How your camera, lenses and batteries survive the Finnish weather – and how to avoid moisture damage when you come in from the cold.
CAN THE CAMERA TAKE IT?
Most cameras work well in the cold, even though the manufacturer's stated operating temperature is often only 0–40 °C. The cold itself rarely breaks a camera. The real dangers are draining batteries, water and above all condensation when a cold camera is brought into a warm room.
The most important rule: When you come in from the cold, put the camera in a sealed bag or camera bag while you are still outside and let it warm up slowly for 1–2 hours before opening it.
BATTERIES AND THE COLD
- The battery drains fast: a lithium-ion battery loses a lot of capacity in the cold. Hard frost can take half or more of the charge.
- Spare batteries in an inside pocket: keep 1–2 spares in your jacket's inside pocket at body temperature and swap them in turn.
- An "empty" battery isn't empty: a battery that died in the cold often works again once it warms up in your pocket.
- Don't charge a frozen battery: let it warm to room temperature before charging.
- Phone and drone: they also shut down in the cold. Keep your phone in an inside pocket and warm the drone batteries before flying.
THE CAMERA AND HANDLING
- The screen slows down: in hard frost the screen may respond slowly or fade. It recovers when it warms up.
- Don't breathe on the viewfinder: your breath fogs the viewfinder and screen instantly. Hold your breath or turn your head while shooting.
- Don't blow snow off: the moisture in your breath freezes on the lens. Use a soft brush or a blower.
- Metal is cold: metal tripod legs and the camera body can freeze bare skin. You can get foam covers for tripod legs.
- Gloves: thin touchscreen gloves under big mittens, or flip-top gloves that let your fingertips out.
CONDENSATION
When a cold camera is brought into warm, humid indoor air, the moisture in the air condenses into water on the camera's surface – and also inside it, on the lens elements and the electronics. The same happens in summer when you take the camera from a cool car into the heat.
Take the memory card out outside
Remove the card (and the battery if you like) while still outside, so you can copy the photos straight away without opening the camera.
Seal the camera in a bag before going in
A large zip-lock bag or a bin bag, air out and the opening closed. A closed camera bag also works as long as you keep it shut. Add a silica gel sachet to soak up moisture.
Let it warm up slowly
Wait 1–2 hours, longer after hard frost. A cool hallway or a cold car is a good halfway stop.
Open it only at room temperature
The moisture now condenses on the outside of the bag, not on the camera. If the lens still fogs up, don't wipe it – let it dry by itself.
Shooting indoors and outdoors in turns? Rather leave the camera in the cold (e.g. in the hallway or the car) than carry it back and forth. Repeated condensation can cause fungus in the lens and corrosion in the electronics.
SHOOTING IN THE RAIN
- Weather sealing is not waterproofing: a "weather-sealed" camera can take splashes and light rain, not a downpour or being submerged.
- Both body and lens: the sealing only works if the lens is weather-sealed too. Many sealed lenses have a rubber gasket on the mount.
- Rain cover: a rain cover made for cameras, or in a pinch a plastic bag and a rubber band with a hole for the lens.
- Lens hood: keeps drops off the front element. A protective filter shields the front element and is easier to dry.
- Change lenses under cover: in the rain water and dust get onto the sensor. Change lenses in the car, under a roof or sheltered by your coat.
SHOOTING IN THE SNOW
- Frosty snow is easy: dry snow doesn't make things wet. Brush it off before the camera's warmth melts it.
- Around zero is the worst: wet sleet and snow near freezing soak things like rain and can freeze in the buttons.
- Snow fools the light meter: the camera turns snow grey. Add +1…+2 EV of exposure and check the histogram.
- White balance: in the shade snow turns bluish. Try the "Shade" WB setting or correct it in the RAW file.
- Falling snow in the photo: flash or a 1/60–1/125 s shutter speed shows the flakes as dots or short streaks.
SITUATION, RISK AND WHAT TO DO
| Situation | Risk | What to do |
|---|---|---|
| Hard frost (below −15 °C) | Battery dies, screen slows down | Spare batteries in an inside pocket, camera off between shots |
| From the cold indoors | Moisture condenses inside the camera | Camera into a sealed bag outside, open only after 1–2 hours |
| Light rain | Drops on the lens, water in the buttons | Lens hood, rain cover or bag, a cloth within reach |
| Heavy rain | Water damage even to a weather-sealed camera | Shoot from under cover or leave the camera in the bag |
| Wet snow and sleet | Gets wet and freezes in the buttons | Rain cover, brush the snow off immediately |
| Aurora and starry night | Front element fogs up or frosts over | A heat pack with a rubber band around the lens, or a lens heater strip |
DRYING IT THE RIGHT WAY
- Wipe the surface at once: dry the body and lens with a towel or microfibre cloth before opening any door.
- Open the doors only when dry: otherwise water runs into the battery and card compartments.
- Let it dry at room temperature: lens caps and doors open, in a dry place for a day.
- No hair dryer or radiator: strong heat can damage the seals and adhesives and push moisture deeper.
- Water inside, or fog in the lens that won't clear? Don't use the camera, remove the battery and take it in for service. Acting fast can save the camera.
WHAT TO TAKE FOR COLD AND WET WEATHER
Read also: Night and northern lights photography, Drone photography and the golden hour calculator for the short winter days.