GUIDE

Av mode for portraits

How to make the most of aperture priority: a sharp subject, a soft background (bokeh) and the right exposure – without having to set everything yourself.

INTRODUCTION

Free the background from distractions

For portraits I almost always use Av mode. A wide aperture keeps the subject sharp while the background melts into a soft, unobtrusive blur. The eye goes straight to the face.

Av mode is especially good for portraits because the most important decision – how much to blur the background – stays with you, while the camera takes care of the exposure as the light changes.

Av – Canon, Pentax A – Nikon, Sony, Fujifilm, Panasonic
PART 1

How does Av mode work?

You choose the aperture, i.e. the f-number, and with it you decide how blurry the background becomes. The camera meters the light and picks a matching shutter speed. If the light changes, the camera changes the shutter speed, but the aperture you chose stays the same.

Remember the rule: small f-number = wide aperture = blurry background. The larger the f-number, the more of the photo is sharp.

PART 2

Basic settings for portraits

A good portrait comes together when these things are right:

  • A fast lens: A prime lens (e.g. 50 mm f/1.8 or 85 mm f/1.8) or a fast telezoom (e.g. 70–200 mm f/2.8) gives you a wide enough aperture.
  • Aperture f/1.8–f/2.8: A small f-number makes the depth of field shallow and separates the subject from the background. For a single person, f/2–f/2.8 is often the safest choice so that both eyes stay sharp.
  • Auto ISO with a minimum shutter speed: Keep the ISO low outdoors (100–400). Indoors or in the shade, use Auto ISO and set the slowest allowed shutter speed in the menu, e.g. 1/200 s, so the photo doesn’t get shaky.
  • Focus on the eye: Use the camera’s eye autofocus (Eye AF). If it doesn’t have one, choose a single focus point and move it over the subject’s eye.
  • Metering mode: Evaluative (matrix) metering works most of the time. In backlight, spot metering on the face helps you get the skin tone right.

Pro tip: Always focus on the subject’s eye closest to the camera. The eyes are the soul of a portrait – if they are sharp, the viewer forgives softness elsewhere.

PART 3

How to get an even softer background

The aperture is not the only tool. Four things together affect how blurry the background is:

  • A wider aperture: The smaller the f-number, the softer the background.
  • A longer focal length: 85 mm or 135 mm blurs the background much more than 35 mm at the same aperture.
  • Get closer to your subject: A shorter shooting distance narrows the sharp zone.
  • Move the subject away from the background: With several metres behind them, the background blurs far more easily than next to a wall.
PART 4

Focal lengths and apertures for different shots

Guideline values for a full-frame camera. On an APS-C camera you get the same framing with a focal length about 1.5–1.6 times shorter.

Type of shot Focal length Aperture Note
Environmental portrait 35 mm f/2–f/4 The surroundings tell a story, the background can show
Half-length portrait 50 mm f/1.8–f/2.8 Natural perspective, versatile
Headshot 85 mm f/1.8–f/2.8 Flattering proportions, soft background
Tight crop 135 mm f/2–f/2.8 Very soft background, needs room
Group photo 35–50 mm f/4–f/5.6 Every row stays sharp
PART 5

Common problems in portraits

Nose sharp but eyes blurry?

At a very wide aperture (e.g. f/1.2–f/1.4) the sharp zone is only a few centimetres deep. Check that the focus point lands on the eye, or stop down slightly (f/2–f/2.8).

The photo is blurred by movement?

In dim light the camera may choose too slow a shutter speed. Raise the ISO, or set the Auto ISO minimum shutter speed to at least 1/200 s.

Overexposed in bright sunshine?

At a wide aperture the camera needs a very fast shutter speed. If the camera can’t go any faster (usually 1/4000 s or 1/8000 s), lower the ISO to 100, use the electronic shutter or an ND filter.

Faces dark in backlight?

A bright background fools the light meter. Dial in positive exposure compensation (+0.7 to +1.5 EV), use spot metering, or bounce light onto the face with a reflector.

The background doesn’t blur enough?

Your subject is probably standing too close to the background. Move them further away from it, get closer yourself and use a longer focal length.

Some faces out of focus in a group photo?

A wide aperture isn’t enough for several rows. Stop down to f/4–f/5.6 and arrange people as close to the same distance from the camera as possible.

Quick checklist

Soft background (bokeh) → small f-number (f/1.8–f/2.8) and subject far from the background
Focus → always on the eye closest to the camera
Dim places / indoors → Auto ISO with a 1/200 s minimum shutter speed
Backlight → exposure compensation +0.7 to +1.5 EV
Bright sun → ISO 100, electronic shutter or an ND filter
Group photos → stop down (f/4–f/5.6)
Next guideTv mode (shutter speed)

All guides · Ask about this guide